Drug Synthesis [A]

Simple One-Pot Synthesis of NEP (N-Ethylpentedrone)

Simple One-Pot Synthesis of NEP (N-Ethylpentedrone)

N-Ethylpentedrone (NEP, 2-(ethylamino)-1-phenylpentan-1-one) is a psychostimulant belonging to the cathinone class. It induces euphoria and increases motor activity. Dosages and duration depend on tolerance to cathinones, ranging from 20 to 60 mg, with effects lasting up to 6 hours.

U9dDCZewlh.jpeg Close Open: U9dDCZewlh.jpeg

Reagents for NEP Synthesis:

Valerophenone – 100 mL
Hydrobromic acid (40-48%) – 160 mL
Hydrogen peroxide (35%) – ~60 mL
Ethyl acetate – 300 mL
Ethylamine – 150 mL
Isopropyl alcohol (IPA) – 30 mL
Distilled water (in excess)
Baking soda (in excess)
Non-iodized table salt

Equipment:

1000 mL beaker
20 mL syringe
Magnetic stirrer with heating

Synthesis of N-Ethylpentedrone:

Stage 1: Synthesis of 2-Bromovalerophenone

  1. Add 100 mL of valerophenone to the beaker with a stir bar inside.
OmXG1fvTJp.jpg Close Open: OmXG1fvTJp.jpg
dLz78GcaJ1.jpg Close Open: dLz78GcaJ1.jpg
  1. Pour in 100 mL of 40-48% hydrobromic acid.
YtgAHP728n.jpg Close Open: YtgAHP728n.jpg
zWZLEJRI2U.jpg Close Open: zWZLEJRI2U.jpg
  1. Start stirring.

  2. Draw 35% hydrogen peroxide into the syringe and add it slowly in small portions.

5smFJlQtUh.jpg Close Open: 5smFJlQtUh.jpg
Y4bpGmr1cO.jpg Close Open: Y4bpGmr1cO.jpg
  1. The mixture will turn red (bromine is released) and heat up.
yxkHh6WeVr.jpg Close Open: yxkHh6WeVr.jpg
rb2c48O0z9.jpg Close Open: rb2c48O0z9.jpg
  1. Wait until the bromine reacts (red color disappears).
zb74cGx2h0.jpg Close Open: zb74cGx2h0.jpg
zRAQjUqtlY.jpg Close Open: zRAQjUqtlY.jpg
  1. Once bromine stops reacting (red color persists or red vapor is visible above the liquid), stop adding peroxide and stir until the mixture becomes colorless (excess bromine evaporates).
58bGkLQNyU.jpg Close Open: 58bGkLQNyU.jpg
LecOzsRimA.jpg Close Open: LecOzsRimA.jpg
  1. Pour in cold water and stir. This cools the reaction and removes excess acid. Use an amount of water based on available space in the reaction vessel.
9UgknEmbjV.jpg Close Open: 9UgknEmbjV.jpg
tidPTwU3ks.jpg Close Open: tidPTwU3ks.jpg
  1. Decant the water or remove it with a syringe (the desired product is the bottom layer).
1lTBg0SPFo.jpg Close Open: 1lTBg0SPFo.jpg
  1. Add a saturated solution of baking soda (use as much as possible without leaving undissolved residue). The volume should match the reaction vessel’s capacity.

  2. Stir, separate the soda solution, and repeat the washing with a saturated solution of non-iodized table salt (prepared similarly).

Yclx3kSVOn.jpg Close Open: Yclx3kSVOn.jpg
qR5SGaJM1P.jpg Close Open: qR5SGaJM1P.jpg
  1. Separate from the salt solution, rinse with clean water, and isolate the bottom layer for further use. Yield: ~150 g.
slAUy1bufR.jpg Close Open: slAUy1bufR.jpg

Stage 2: Synthesis of NEP from 2-Bromovalerophenone

  1. Add 300 mL of ethyl acetate to the 150 g of 2-bromovalerophenone and stir.
Ip7TsQarVz.jpg Close Open: Ip7TsQarVz.jpg
ULwZjkIQuY.jpg Close Open: ULwZjkIQuY.jpg
  1. Add 150 mL of 70% ethylamine and heat the mixture gradually (do not exceed 70°C).
RuYOQ2UcfD.jpg Close Open: RuYOQ2UcfD.jpg
tUF5mXpkTN.jpg Close Open: tUF5mXpkTN.jpg
  1. Reaction time at optimal temperature (~60°C) is 20-30 minutes, but longer times won’t harm the reaction. If yield is low, extend the time.
ZzVqFU4sra.jpg Close Open: ZzVqFU4sra.jpg
  1. After 30 minutes, add cold water and stir to remove excess ethylamine.
PeSsmR2Dbt.jpg Close Open: PeSsmR2Dbt.jpg
uMFbS2LleN.jpg Close Open: uMFbS2LleN.jpg
  1. Let the layers separate (the top layer is ethyl acetate containing the product in freebase form).
CrBLJpAf9F.jpg Close Open: CrBLJpAf9F.jpg
UBMwJYT7it.jpg Close Open: UBMwJYT7it.jpg
  1. Separate the lower aqueous layer from the upper one. Repeat washing if the ethylamine smell persists.

  2. Using a syringe, slowly add hydrobromic acid (or hydrochloric acid) dropwise while stirring. Avoid excessive heating (to prevent ethyl acetate hydrolysis).

SWOHAZz9lE.jpg Close Open: SWOHAZz9lE.jpg
nsHaLeZP3Q.jpg Close Open: nsHaLeZP3Q.jpg
  1. Continue adding acid until product formation stops (no localized reddening upon stirring) or use pH strips (pH ~3). In this case, 58 mL of 48% HBr was used.
vEHOAhjgXC.jpg Close Open: vEHOAhjgXC.jpg
0UPI9oN8hE.jpg Close Open: 0UPI9oN8hE.jpg
  1. Add 60 mL of water and continue stirring with heating until the solution clarifies (all product dissolves in water).
DopdVT98I7.jpg Close Open: DopdVT98I7.jpg
1Xx34BnZHk.jpg Close Open: 1Xx34BnZHk.jpg
  1. Separate the upper ethyl acetate layer (contains impurities) from the aqueous layer (contains dissolved NEP).

  2. Mix the aqueous layer with 30 mL of isopropyl alcohol, stir, and let it crystallize. To speed up crystallization, use a shallow Pyrex dish or refrigerate at +5 to +7°C.

pe0NrSiumC.jpg Close Open: pe0NrSiumC.jpg
O9wE4mDvfW.jpg Close Open: O9wE4mDvfW.jpg
  1. Within 24 hours (faster in the fridge), crystals will form. For larger crystals, add more water and alcohol (e.g., +60 mL water +15 mL IPA). Maximum yield: ~127 g.
A4whMcbNRP.jpg Close Open: A4whMcbNRP.jpg
hAS3EUvb50.jpg Close Open: hAS3EUvb50.jpg
WZt5cXGd21.jpg Close Open: WZt5cXGd21.jpg
2KgCPfUoZL.jpg Close Open: 2KgCPfUoZL.jpg
E13pmzjoLd.jpg Close Open: E13pmzjoLd.jpg
Ry8SelHfpi.jpg Close Open: Ry8SelHfpi.jpg

Conclusion

NEP can be synthesized relatively easily without complex equipment. A hot water bath, thick glass bottles, and manual stirring can replace lab tools. The reaction can proceed without heating but will take longer. For fine crystals, filter through uncolored fabric or coffee filters. To recover product without filtration, dissolve large crystals and air-dry to constant weight. Do not discard the mother liquor until maximum yield is achieved.

Источник: http://bbzzzsvqcrqtki6umym6itiixfhni37ybtt7mkbjyxn2pgllzxf2qgyd.onion/threads/simple-one-pot-synthesis-of-nep-n-ethylpentedrone.16549/

↑ 0

Discussion

Comments

0

No comments yet.

Write Join to take part in the discussion.