Forum guides [A]

How to make a single thread private

Interface language

Inside an open community you sometimes need a narrow-circle discussion — moderation plans, a deal with a partner, details that are not for everyone. When creating the thread, set Access mode to Invite only or By conditions; the thresholds for conditions are entered right there, before publishing.

Immediately after publishing, the Thread settings page opens: there you can change the mode and create an invitation link in the Invitations block. The thread's author and the community owner can open that page. The form hints state the rules honestly: an ordinary thread link grants no access, and any mode works only inside the section and community the reader can already reach.

Check the result as an outsider would: a private thread must not show up in shared lists or search. If an invitation does not work, see whether the level above is closed or the link has expired. And remember: a thread never opens a private community and never replaces access to it.

Questions? Post a comment below.

↑ 7

Discussion

Comments

2

Newest comments come first at each level; replies stay under their parent.

Write Join to take part in the discussion.

Logged-out check is a good idea but a private community member's preview still lies to you. Ask someone who isn't in the section at all. Also worth testing with the section collapsed, since nested access is where these modes usually break.
↑ 0 Reply
Worth stressing the invitation links expire — I'd set a short window rather than leave one sitting in a chat log forever. Also check from a logged-out browser, since a moderator preview can still see things an outsider can't.
↑ 0 Reply