2-Bromo-2-cyclohexyl-1-phenylethanone.
Synthesis of alpha-PCyP
Закрыть
Открыть: nArCJoLBtY.png
-
1000 g of 2-cyclohexyl-1-phenylethanone and 3000 ml of acetic acid were mixed in the reactor.
-
Turned off stirring and left during at room temperature.
-
The pure bromine (800 g) was neatly poured into the reactor and left in a mixture without stirring.
-
After some time, the reaction autorun occurred, severe hydrobromic acid gas leading.
-
Gas is bubbled into a mixture with absorbent (aqueous solution of sodium hydroxide, 400 g for the whole amount of water).
-
When reducing the rapid evolution of gas began stirring cautious.
-
At the end of the gas is released, and the reaction has cooled to room temperature (crystallization may start), 9000 ml of pure cold water slowly poured (сrystals are formed).
-
After 15 minutes, stirring stopped, the sediment of the bromoketone was fall on the bottom (yellow solid).
-
The water layer was separated through the top of the reactor and was re-washed with a saturated solution of soda, and clean water.
-
Used in subsequent reactions without further purification, yield: 1300 g.
2-Cyclohexyl-1-phenyl-2-(pyrrolidin-1-yl)ethanone Hydrochloride.
Закрыть
Открыть: AWejxbGXLd.png
-
Added 4 litres ethyl acetate in the reactor and stirring 5 minutes.
-
Added 1000 g pyrrolidine into the drop funnel and mounted on the reactor cover.
-
Open tap drop funnel and added pyrrolidine dropwise, with intense stirring.
-
Check temperature below 65 *C.
-
After all pyrrolidine added, inteximally stirred 1 hour.
-
Turn on reactor vacuum pump and chiller pump for reactor condenser.
-
Distilled all or most amount of ethyl acetate.
-
Stop vacuum pump and added in the reactor acetone. Stirring continues.
-
Added hydrochloric acid into the drop funnel and mounted on the reactor cover.
-
Dropwise acid to pH - 5. Drain a small amount from the bottom reactor tap and control the level of acidity with a litmus strip. Return the sample to the reaction mixture.
-
After that, poured all mixture in bucket and put in the freezer for 12 hours.
-
Installed by vacuum filtration system (nutsche filter, filter cloth, vacuum pump).
-
Start vacuum pump.
-
Pour a bucket from step 13 to the filter bowl.
-
Filter and press until the mixture of the bowl becomes solid.
-
Pour cold acetone into the bowl to cover the whole solid from above.
-
Filter all acetone. Repeat step 18 if the solid is not white.
-
After filtered all acetone and achieving white solid, put the contents of the bowl in the glass containers for drying.
-
Put the glass containers on racks at room temperature.
-
Dry to constant mass. Periodically mix and grind, for faster drying.
Написать Join — чтобы участвовать в обсуждении.