Introduction
I represent to BB audience Methamphetamine synthesis method of 1-phenyl-2-propanon (P2P) reductive amination by NaBH4. Following method allows obtaining and large batches of product. The hardest problem of this method is the heat generating during exothermic reaction of imine reduction. Extremely important keep temperature in described frames and keep all reagent and reaction atmosphere dry (use drying tubes with CaCl2). Also, manipulations with NaBH4 is quite dangerous and take a lot of attention because this reagent has toxic effects, reacts with water and alcohols with releasing enormous amount of hydrogen and form the corresponding borate, it may cause an explosion, burns and injuries. You have to use chemical glass, gloves, chemical coat and respirator.
Equipment and glassware:
Ceramic mortar;
2 L (x2), 0.5 L (x2) and 200 ml (x2) beakers;
2 L (x2) and 10 L Erlenmeyer flask;
Measuring cylinder for 100 ml;
2 L three-necked round bottom flask with plugs;
2 L round bottom flask with vacuum quickfit or Schlenk flask;
0.5 L Simple dropping funnel with Claisen flask and drying tube or 0.5 L equal pressure dropping funnel;
1 L Separator funnel;
2 L Evaporation flask;
Pyrex dish 0.5 L;
Magnetic stirrer with heating plate;
Retort stand and clamp for securing apparatus;
Silicone-oil bath;
Icecubes/methanol bath (-10 °C) or Mashed ice with salt (-10 °C);
Laboratory scale (1 g-1 kg is suitable);
Oven;
Laboratory grade thermometer (-20 °C to 200 °C) with three-necked flask adapter;
Aspirator;
HCl laboratory generator;
Drying tube x2;
Rotavap machine with water bath;
Filter paper.
Reagents:
138 gram P2P (1 mole) (1-phenyl-2-propanone);
10% Methylamine in Methanol (w/w) - 1000 ml with 100 g MeNH2 (~3 moles);
Magnesium Sulfate - 36 g (MgSO4·7H2O, oven dry at 300 °C for 2h MgSO4·1H2O) [For drying MeOH/MeNH2 solution];
Silica Gel (3-5 mm balls) - 200 ml (dry at 300 °C/2h, they will darken!) [For absorbing 2 mol H2O during rxn];
15 gram NaBH4 as a reducing agent for the formed (water-free!) imine;
5-7 L distilled water + ~5 L distilled water to filling rotavap machine bath;
1 L Dichloromethane (DCM);
0.5 L Acetone.
Important: the reaction is very sensitive to any water (fluid or vapour in the air!).
Note: hold all manipulations in pull out probe or under exhaust hood; methylamine is a rather toxic substance, do not let its vapors enter the respiratory tract. Using respiratory mask is required. Inhalation of methylamine causes severe skin irritation, eyes and upper respiratory tract. Firstly, leads to excitement and then to depression of the central nervous system. Death can occur from respiratory arrest.
Procedure
Precursors drying
First quickly crunch your pre-dried (oven, 300 °C, 3 hrs.) dry MgSO4 to pop corn shaped rocks in a mortar, sieve the powder out, and directly put the rocks under max. mixing in the Methanol/Methylamine mix (1000 ml) and close the pot to let no water from the air in. Keep mixing for 10 minutes, then all the water will be taken up to the MgSO4. Let stand and wait till all the MgSO4 is on the bottom. Now quickly tap off the now dry MeOH/methylamine (MA) mix in a 2 L three-necked round bottom flask and close that one. Wash directly your empty pot with lots of water, to remove the smell of methylamine, so you can safely store it.
Synthesis
Now add the 200 ml (measure in beaker, neglect the free spaces) dry Silicagel beads (2-5 mm) and a magnetic mixer bar also in the 2 L flask and close again. Keep 2 L flask in Silicone-oil bath at 20 °C. Silicone-oil only slowly warms up! Do not apply heat now, it's only meant as a cooling medium in this stage. Now add slowly via a dropping funnel the 138 g P2P to the 2 L flask under strong mixing. The temperature rises to 23 °C during the (water-free) Imine forming. The water from this reaction is taken up by the dried Silicagel! This takes 30 minutes. Let, then mix for another hour. The reaction mix color changes from light yellow to coffee+milk color. Temp 23 °C.
Написать Join — чтобы участвовать в обсуждении.